Bamboo habitat

The forum for the very best information on loaches of all types. Come learn from our membership's vast experience!

Moderator: LoachForumModerators

Post Reply
andyroo
Posts: 886
Joined: Wed Jan 11, 2006 10:00 am
Location: Mo-Bay, Jamiaca
Contact:

Bamboo habitat

Post by andyroo » Thu Dec 27, 2007 3:04 pm

Re; bamboo for loach hide-outs:
How do you get it to sink? Will it eventually sink with soaking?
Decomposition? Are there types/species of bamboo to be avoided?
A
"I can eat 50 eggs !"

mickthefish
Posts: 3281
Joined: Sun Sep 10, 2006 7:20 pm
Location: manchester, england

Post by mickthefish » Thu Dec 27, 2007 3:51 pm

if i was doing them i'd use silicone to anchor it to a piece of rock or bogwood,
you could always use fishing line to fix it to something heavy, then you could put some jave moss to make it more realistic.

mick

User avatar
Emma Turner
Posts: 8901
Joined: Wed Dec 28, 2005 5:07 pm
Location: Peterborough, UK
Contact:

Post by Emma Turner » Thu Dec 27, 2007 4:03 pm

The first time I did the display tank at the shop with bamboo (large upright pieces) I had little trouble. I used an aquarium-safe 2-part putty (as is used for fragging corals) to stick the bottom of each piece to reasonably sized pieces of slate. This slate was then buried in the sand substrate:

Image
2004

The second time around, however, the bamboo ended up being much more bouyant (it did look the same, but was from a different source). Despite puttying it to the slate as I did before, most of it ended up floating. I was highly stressed out at this point as I was working on this after the shop was closed and only had so many hours to sort out the mess I'd made. I ended up having to drill lots of small holes in the back of each piece of bamboo (done so it couldn't be seen from the front) in order for each section to fill up with water. Any pieces that happened to be cut so that there was a large hollow section at the top, had that filled with gravel as well. Each piece had to be held down until it filled with water and eventually sunk.

Image
2007 (just after adding the new bamboo - hence the yellow colour - this soon turns browner and gets covered in algae).

Of course, if you are planning to use the bamboo as horizontal tubes, cutting each section so that it has no middle chamber (i.e. cut each piece just before the dividing 'skin' in each section) and sticking to slate - either permanently with aquarium safe putty, or temporarily somehow until the bamboo becomes waterlogged - should work.

I should just point out that bamboo must be used carefully in a closed aquarium system as it does rot down over time. This is not a problem in the large display tank at work because of the amount/volume of water changed every day, but large amounts of bamboo in smaller tanks that are not waterchanged so frequently can cause major problems.

Hope this helps,

Emma
Image
East of the Sun, West of the Moon.
Image

Diana
Posts: 4675
Joined: Wed Jan 04, 2006 1:35 am
Location: Near San Franciso

Post by Diana » Thu Dec 27, 2007 11:58 pm

What about drilling holes through all the interior sections, some from each end? Then fill the upper section with gravel to keep the fish out.
Yes, it takes a long drill bit. They are available...
38 tanks, 2 ponds over 4000 liters of water to keep clean and fresh.

Happy fish keeping!

Post Reply

Who is online

Users browsing this forum: No registered users and 291 guests