Finally got the tank :D

The forum for the very best information on loaches of all types. Come learn from our membership's vast experience!

Moderator: LoachForumModerators

User avatar
adampetherick
Posts: 296
Joined: Sat Jul 15, 2006 5:53 am
Location: Fleet, Hampshire, England
Contact:

Finally got the tank :D

Post by adampetherick » Thu Aug 24, 2006 3:57 pm

After a long wait and a few discussions with the landlord I'm finally getting my tank tomorrow :D

Here's the setup:

Fluval Duo Deep 1200 Kit but swapping the standard filter that comes with it for an fx5
Black Sand Substrate
Lots of plants (few plastic/silk) and real ones
Few plastic wood branches

I've been told a few conflicting stories by different pet stores about stocking amounts and times.

So I thought I'd check with the experts on here

1) How many fish would this tank hold? The plan is 9 Clowns, 7 Pentazona Barbs and 15 Leopard Danio's + 1 other (below)

2) Is there an Asian equivalent to the pleco as the girlfriend wants a fish to name? or another fish that grows to a decent size that's fine with the others

3) How long after the amonia and nitrate levels have dropped to zero can I start adding fish and in what order as the shop I went to today said 5-6 months before adding the clowns?
Last edited by adampetherick on Fri Aug 25, 2006 5:41 pm, edited 1 time in total.

User avatar
mikev
Posts: 3103
Joined: Sat Feb 04, 2006 6:06 pm
Location: NY

Post by mikev » Thu Aug 24, 2006 4:05 pm

Congradulations!

Uggh...Just how big is the tank?

User avatar
adampetherick
Posts: 296
Joined: Sat Jul 15, 2006 5:53 am
Location: Fleet, Hampshire, England
Contact:

Post by adampetherick » Thu Aug 24, 2006 4:07 pm

120cm wide x 40 Deep x 45 Height

which works about 216 litres

216 liter = 57.061 163 068 gallon [US, liquid]

User avatar
Emma Turner
Posts: 8901
Joined: Wed Dec 28, 2005 5:07 pm
Location: Peterborough, UK
Contact:

Post by Emma Turner » Thu Aug 24, 2006 4:19 pm

You should be ok with that set-up for a while, as the filtration you have done a swap for is pretty decent. The clowns will certainly appreciate the flow. Long term, they are going to need more space, so be prepared to upgrade in a few years time.

I would agree with what the shop said about stocking slowly. The clowns, due to their sensitivity, will need to be the last type of fish you add, so that your system has had a good chance to mature. Your best bet will be to add a small shoal of danios once ammonia and nitrIte levels have both zero'ed out. Feed lightly and monitor the water over the next few weeks, and providing ammonia and nitrIte are both on zero, you can then consider adding the barbs.

I would suggest getting yourself a nice species of Garra instead of the pleco. These are Asian species that feed primarily on algae and some are absolutely stunning e.g. the Panda Garra - Garra flavatra or the Rinocerous garra - Garra bicornuta. They will get on fine with all the other inhabitants you suggest.

Wait as long as you can until adding the clowns. Five or six months from the setting up of a new aquarium is what I would personally recommend, particularly if you are new to keeping Botia.

Best of luck,

Emma
Image
East of the Sun, West of the Moon.
Image

Eyrie
Posts: 160
Joined: Fri Jul 21, 2006 3:58 pm
Location: Edinburgh, Scotland

Post by Eyrie » Thu Aug 24, 2006 4:25 pm

Sorry to say that that tank isn't big enough for nine clowns. You'd be able to keep 3-5 in there for a few years, but will need to upgrade eventually.

I assume you want a pleco or equivalent for any algae that may occur? In which case the siamese algae eater is a good fish.

The leopard danios would be the best fish to add first, followed by the barbs. The LFS is right about waiting several months to add clowns. Are you going to do a fishless cycle or use the danios?

User avatar
adampetherick
Posts: 296
Joined: Sat Jul 15, 2006 5:53 am
Location: Fleet, Hampshire, England
Contact:

Post by adampetherick » Thu Aug 24, 2006 4:30 pm

We're buying a place in about a year so won't have the restrictions about tank size so upgrading won't be a problem :D

User avatar
shari2
Posts: 6224
Joined: Wed Aug 02, 2006 2:17 pm
Location: USA

Post by shari2 » Thu Aug 24, 2006 4:30 pm

So, you have a tank of about 57 gallons.

9 clowns
7 barbs
15 danios
1 pleco equivalent

First question: How big are the clowns you plan to get, and are you aware that they will get big if well cared for? Look at some of Emma's pics of her gang of clowns 8)

your barbs will acheive 5cm each
leopard danios can get to 6cm
Plecos? Well, since that's an unkown at this point we can't really say.

I currently have 6 clowns in my 55gallon. Two I am now looking for a home for since they are really too big for my tank at about 8 inches. The others will keep growing too. If I want to keep them I really need a tank of about 125 gallons.

The three clowns I started with were small and still are fine in my tank. I aquired the other three from a friend and didn't realize just how small a 55 could look until they got here. :roll:

Since you have had a hard time getting the ok from the landlord for this tank I don't know how well an even larger one will go over? In any case, I think 9 is too many, but that is my opinion, and I tend to understock rather than overstock.

Cudos to you for looking for information before you set up the tank! Alot of us learned the hard way ...

User avatar
adampetherick
Posts: 296
Joined: Sat Jul 15, 2006 5:53 am
Location: Fleet, Hampshire, England
Contact:

Post by adampetherick » Thu Aug 24, 2006 4:32 pm

Eyrie wrote:Are you going to do a fishless cycle or use the danios?
Will be doing it fishless

User avatar
adampetherick
Posts: 296
Joined: Sat Jul 15, 2006 5:53 am
Location: Fleet, Hampshire, England
Contact:

Post by adampetherick » Thu Aug 24, 2006 4:35 pm

shari2 wrote:
First question: How big are the clowns you plan to get, and are you aware that they will get big if well cared for? Look at some of Emma's pics of her gang of clowns 8)
Will be getting the smallest ones at the LFS, about 1-1.5" iirc
shari2 wrote: Cudos to you for looking for information before you set up the tank! Alot of us learned the hard way ...
Been doing lots of research since my last thread http://forums.loaches.com/viewtopic.php ... highlight=

User avatar
mikev
Posts: 3103
Joined: Sat Feb 04, 2006 6:06 pm
Location: NY

Post by mikev » Thu Aug 24, 2006 4:43 pm

Always good to plan....

Concurring on 9 being too many. You should probably start with about five (say three first, make sure everything is ok, add two more --> gives you a reasonable troupe).

Fishless cycle is the way to go!

In fact, with established fishless cycle you can add a lot of fish at once. The only thing you need to make sure is that your nitrAtes at the end of the fishless cycle are not too high, but you can do a very large water change if needed -- before any fish has been added. (This does not mean that you can add clowns faster, of course).

I'd personally go with somewhat larger dither, more comparable in size to the clowns who will grow to 3" soon enough (the clown dither fish here is Giant Danios, in the next larger tank probably the Rainbows...)

Good luck!

User avatar
adampetherick
Posts: 296
Joined: Sat Jul 15, 2006 5:53 am
Location: Fleet, Hampshire, England
Contact:

Post by adampetherick » Thu Aug 24, 2006 4:57 pm

one final question, I've ordered this background for the tank

http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... %3AIT&rd=1

Can the filter/heaters go behind this or will it mean that the main part of the tank in front of it won't get filtered/heated properley?

Mark in Vancouver
Posts: 14252
Joined: Wed Dec 28, 2005 12:41 pm
Location: British Columbia

Post by Mark in Vancouver » Thu Aug 24, 2006 8:15 pm

You want your filter intake and output - and your heater - to be in the larger volume of water. Be careful, too, to seal the edges of that backing into place. Otherwise, you'll rarely see your loaches.
Your vantage point determines what you can see.

User avatar
adampetherick
Posts: 296
Joined: Sat Jul 15, 2006 5:53 am
Location: Fleet, Hampshire, England
Contact:

Post by adampetherick » Fri Aug 25, 2006 5:01 pm

Firstly I'd like to thank all of you for making me spend so much money!

Went to pick up the Fluval 1200 but they had none in stock so I'm now the owner of a Juwel Vision 450 :D

(Volume: approx. 450 Litres, Measurements: 151 x 61 x 64 cm)

Can I now get away with the original stock levels in this thread?

Also incase anyone is interested, you can fit the tank and stand in the back of a Vauxhall corsa

Image

User avatar
sophie
Posts: 1883
Joined: Sat Dec 31, 2005 10:15 am
Location: birmingham. definitely not Alabama!
Contact:

Post by sophie » Fri Aug 25, 2006 5:21 pm

seriously excellent photo!

keep posting updates.
and photos.
sounds very good indeed - and I hope your landlord is happy and your floors are strong...
sophie.
there is no them
there is only us

http://www.duckduckgoosestuff.co.uk

User avatar
adampetherick
Posts: 296
Joined: Sat Jul 15, 2006 5:53 am
Location: Fleet, Hampshire, England
Contact:

Post by adampetherick » Fri Aug 25, 2006 5:36 pm

sophie wrote:seriously excellent photo!

keep posting updates.
and photos.
sounds very good indeed - and I hope your landlord is happy and your floors are strong...
We're on the ground floor and I'm 99% sure they are concrete floors, Will get some photo's of the tank setup tomorrow once I've got some plants in there. Might also get to make use of the free waterproof camera I got from Thomas Cook when I bough currency a while back.

Took ages to fill and really not looking forward to doing water changes!

Post Reply

Who is online

Users browsing this forum: No registered users and 289 guests